12v wiring question...advice needed

Ive done a forum search and found the answers to most of my issues but haven’t found the answer to this… how exactly do I physically wire up my crix complete kit with canakit amp and distortion fix to run off the same 12v battery? (I know the sound chip is a seperate source) Do I use a power block or some other way to distribute power? I have everything else figured out, just want to use one battery.

My specific setup is:

-Crix wand/pack/sound kits

-Canakit 7w amp

-Spongeface distortion fix board

-12v 6800mah blue eBay battery

Sent from my SAMSUNG-SGH-I777

I built my own power supply block using some trace wire and perf board.

Never give your sound chip more power than 3V.

I recommend running your battery power to a main kill switch and then to your “power supply” for the lights and amp.

image

image

Its hard to tell because of the rats nest I got going there but I had my 12 power come in on the top line, then feed to my Amp and a DPDT Switch in the gun.

When activated that DPDT switch feeds power to the lower line powering my Pack and Wand lights.

Everything that gets 12 volt power is attached to a common ground on the left there.

Its fairly easy to get done and I would use a breadboard to test it all before soldering it down.

Good luck!

EDIT: This setup was for Crix pack lights and Jupiter Wand lights so wiring a complete Crix light setup may be easier.

Personnaly I use the 3 kits from crix and when I put it on 12v. the slo-blo busted and when I was shutting down the power the bargraph was still running with half power (very low light) so I have no choice… 3v for soundboard, 9v for light and a blue 12v battery for amp… next year I will try to correct some component on the gun board to be able to run on 12v without problem…

Thanks for the reply gekx. Its got my wheels turning :stuck_out_tongue:

Yeah that happens to me too, I didn’t blow any lights though. I haven’t really run it very long while hooked up to 12v because its made me so cautious. Maybe one of the 12v to 9v step down modules on eBay would do the trick?

Sent from my SAMSUNG-SGH-I777