# Help with the Prop Forge Light Kit

**URL:** <https://forum.gbfans.com/t/help-with-the-prop-forge-light-kit/14027>\
**Category:** Proton Packs\
**Created:** [October 19, 2015, 12:10pm UTC](https://forum.gbfans.com/t/help-with-the-prop-forge-light-kit/14027 "2015-10-19T12:10:03Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![Ramjet](https://forum.gbfans.com/user_avatar/forum.gbfans.com/ramjet/32/5934_2.png) [@Ramjet](https://forum.gbfans.com/u/Ramjet)\
**Post date:** [October 19, 2015, 12:10pm UTC](https://forum.gbfans.com/t/help-with-the-prop-forge-light-kit/14027/1 "2015-10-19T12:10:03Z")

</div>

I’m looking at a pack for one of the members here.

It has the GBFans sound kit and the PropForge light kit.

The light kit used to work, but then just stopped with the bottom light on the wand [bar graph](https://www.gbfans.com/wiki/equipment/proton-pack/bar-graph).

When I power the kit up, the arduino board gets red hot, and the fault is with the power distribution board.

With only the activation switch connected the processor gets hot, and I would like the trace the path of the activation switch on the [motherboard](https://www.gbfans.com/wiki/equipment/proton-pack/motherboard). Of course, it can be done tracing tracks on a PCB, but a schematic and overlay is much much easier.

It is possible the processor has already been cooked, in which case I’d also be looking for the arduino code to download into a replacement board.

Does anyone have a schematic of the Prop Forge board, or the arduino code?

Any assistance appreciated.

Dave.

---

<div class="post-metadata">

**Author:** ![rgamble84](https://forum.gbfans.com/user_avatar/forum.gbfans.com/rgamble84/32/6563_2.png) [@rgamble84](https://forum.gbfans.com/u/rgamble84)\
**Post date:** [October 18, 2020, 10:27pm UTC](https://forum.gbfans.com/t/help-with-the-prop-forge-light-kit/14027/2 "2020-10-18T22:27:26Z")

</div>

you may need a new 8 pin cable. the same one running the gbfans wand to pack