ID Badges and Holders

Dumb question but how do you attatch the GB pin to the badge? Also I can’t order with a blank seal

I used JB weld, also I called them and asked them to leave the seal blank.

That’s a better idea than mine, I just ordered a random seal and held it over a boiling kettle to steam it off. Worked a treat but it would have been easier without one.

I looked into getting a badge like that made. Found some really nice ones out there. I may end up having to really get one now after seeing how awesome they look.

I found a canadian maker of badges and ordered one, i went with a medium size, the pin will be tight but it will work

here’s a mock up for my badge and id card, will post the physical copies when i receive them

image

image

Is thats a scale insert of the pin everyone is using, you are probably going to find that badge is a bit on the small side. When you post a pic of the badge, please also put something for scale in the pic as well, like a ruler or quarter or something

I hope they caught the typos and fixed them.

The missing L in Alberta was the first one that jumped out at me, but there are a couple more.

Alex

They are probably going to do exactly what you sent them.

facepalm shoot didn’t nottice that, gonna have to get it reprinted

Shows what happens when you don’t proof read, only out $11.00

Woot, ID and pin have arrived. sheild and wallet are enroute. should have pics by the weekend. just need to pick up epoxy

Two questions…

  1. From what I can tell, all that is on eBay with the pins are of gold enamel/plating.. for those with a silver badge, how bad does it contrast?

  2. What size badge did y’all use?? The pins seem to range from 1" to 1-1/4" wide and badges come in many widths.

Look for old vintage ghostbusters pins. They have a sparkle in them that looks the best on badges like the one I have. https://www.ebay.com/itm/Ghostbusters-1984-Promotional-Pin-Rare-Vintage-Kenner-Employee-Original-MINT-/184361867713

This one is really expensive. But you can find them time to time under $20.

I just noticed that question was put out 7 years ago. Oh well