# Trap Electronics/Code (Sean Charlesworth)

**URL:** <https://forum.gbfans.com/t/trap-electronics-code-sean-charlesworth/38791>\
**Category:** Ghost Traps\
**Created:** [March 20, 2023, 8:04am UTC](https://forum.gbfans.com/t/trap-electronics-code-sean-charlesworth/38791 "2023-03-20T08:04:18Z")\
**Posts on this page:** 1\
**Page:** 1

<div class="post-metadata">

**Author:** ![JacqueTheDoor](https://forum.gbfans.com/letter_avatar_proxy/v4/letter/j/2bfe46/32.png) [@JacqueTheDoor](https://forum.gbfans.com/u/JacqueTheDoor)\
**Post date:** [March 20, 2023, 8:04am UTC](https://forum.gbfans.com/t/trap-electronics-code-sean-charlesworth/38791/1 "2023-03-20T08:04:18Z")

</div>

Thought I’d ask here before doing some deep digging.

I had the trap finished, with pedal all working with your code. I had to adjust the door settings slight so they open and close nicely without hitting each other.

Then gave a go at adding in new part to the code so that the states went like this, similar to ‘gpstar’ code as his wasn’t working on my board for some reason even the V2.0.

Open, just bright light

Capture, flickering

Trap, baragraph and what not

Reset.

Either way it didn’t work as intended and went to go back to your original code and noticed its not triggering anything, you start it and it beeps and the baragraph lights up but then when you press [side knob](https://www.gbfans.com/shop/ecto-goggle-side-knobs) or short the foster connector nothing.

Any ideas?

I noticed the servo’s were hot but they still kinda work if adjusting the int setup in the code

I’ve unplugged everything individually to see for some reason if wire had done anything though it was stationary on my bench and everything got correct Live and Earth

Thanks

Jacque
