Unlicensed Nuclear Accelerators are cool.

Hey fellow proppers recently I have broke ground on my proton pack project. It wasn’t nearly as hard as one would think and is going relatively smoothly.

The circle came out wonky but it can be sanded down right so I’m not worried.

Next I was able to finish the EDA box assembly. Also attached and outlined some more of the Cyclotron Motor Housing and attached the piece that will become the top curvature of it.

I would also like to add that you do not have to do the pieces out of wood like I am. I am just doing it to get an authentic weight and technically the plans i’m using call for the 1/4" plywood that i’m using. I am leaving it hollow however so it doesn’t get overly heavy.

Inside of the EDA

EDA installed on the Motherboard.

Next I got the holes drilled in the pans and the Cyclotron housing started up. Unfortunately the hole drill dented the pans so I have to figure out how to smooth that out. Also worked more on the cyclotron housing.

Thought I had the measurements right on the Power cell so far but it turns out their were some mis-measurements on it that I now have to rectify. I should be ok to continue construction though. It just needed a lot of extra work to make it look good. All the issues i’m currently having could be fixed with the use of a band saw. but unfortunately I do not own one. Oh well you can’t make an omelet without breaking some eggs. Oh also finished covering the Cyclotron Housing, and drilled the hole for the proton wand hose.

The glue and wood scraps filled the gap between the EDA and Power Cell nicely and put wood filler in the gaps. Everything turned out fine and work can continue. It turns out I also had to cut off and re glue the top motherboard piece back onto its correct spot.

Finished up work on the PowerCell, and some of the cosmetic plating. Also got to work on the Ion Arm and have it about 90%. Just got to let it dry and mount it to the EDA. Started to even out the Cyclotron Motor lid, because of the dents from drilling the holes in it as well.

Had another small problem however with splitting on the tubes holder coming out of the Power Cells bottom, as you can see in the pictures, but the second one I cut turned out a lot better and I pushed onward.

Hope you all enjoy my work so far and feel free to post comments and suggestions to me.

Cheers! -Hawkrin

Awesome job so far! I love seeing scratch built packs!

Hey fellow Proppers! I have been at it again today working on the pack and have finished the N-Filter, some initial painting, and the Gearbox. No issues today at all actually. I will say however that those strips are a pain in the ■■■■ without a band saw, because my skill saw is not small enough to cut tiny end pieces like I need.

Oh well, another productive day today.

Cheers! -Hawkrin

Hey ya’ll its been a very long time since i’ve posted but the pack is in a 95% complete state and I even took it to a cosplay picnic last summer. I plan on finally getting more done on it and getting my flight suit finished too. Here are the pictures as it seems all the picture links were broken.