Update!
I managed to get some stuff done… not much, but I got to drill some stuff, fill, sand, sand some more…
I drilled the end piece of the gun, and also cut the acrylic tip
Glued the whole thing together
I’ve always felt I was running short on space on the right side of the graph bar and since I’ll be getting Exoray’s wand light kit, I had to get rid of the frame around the graph bar anyway.
I used some epoxy putty to fill in the hole.
After sanding the epoxy. Looks rough but it’s very smooth. I’ll then apply primer, re-apply some more epoxy, sand again, and re-apply primer. Once I have the bar, or the exact measure, I’ll proceed and drill a new hole.
Applying primer to some parts that were ready to go.
Now onto the pack! This is the pack as it came outside the box. I didn’t do any drilling today. I sanded the whole thing with a 220 grit, washed it with some water to get rid of the fiberglass dust, and wet sanded the shell.
As it came out of the box.
After sanding with 220 grit.
After wet sanding the shell for a smoother finish
MMM’s motherboard.
ALICE Frame. This one I got around 8 years ago. It has weird mustard yellow straps. I’d like to see if they can be replaced for the green ones. I don’t know much about this frame. I got it from ebay and I think this one will have to do. Do you know if those straps can be replaced?
That’s it for now! 