Recently loly2kn2 was kind enough to point me to a nice reference shot I’d managed to miss when it first showed up (due to being slammed with work) that showed clearly where the 3rd mounting point on the frame was to the mobo.
Neat, and thanks… however I noticed something that has been bugging me since.
See the back of the powercell? What are those three nuts/rivets? On Ken’s mid-grade pack they weren’t there (or don’t seem to be - feel free to correct me) so I figure it’s some sort of hero only thing.
However they don’t seem to be mounted to anything - unless they are some sort of mount for the injectors (which, looking at photos again, seem to have a thin metal plate between them and the powercell).
I thought about that - but looking at Ken’s pack they seem to be mounted to the pack itself - they are after all just on a breadboard. It’s not exactly heavy.
While Ken’s pack wasn’t a hero (it was a mid-hero, a cast of a hero to act as a mid-hero when closeups weren’t needed but stunt packs would look like ass) I see no reason for them to have done much different with the electronics.
Well, the pack in this picture is a GB1 pack that was retro-fitted for GB2. On ken’s the power cell lights are actually bolted to the side of the powercell, like so:
And how that looks on the outside of the pack is like this:
See on the powercell, you can see two black screws.
Where am I going with this? Well basically, any pack that has the powercell lights attached to the fiberglass shell like Ken’s will have these screws on the outside. Since both the pack in your original picture and the GB1 Hero packs do not have any kind of screws holding the lights to the shell, I believe the 3 rivets under the powercell, on the motherboard, are indeed used for holding the lights to the motherboard in the GB1 Hero packs and the ones that were retro-fitted for GB2.
i chose to install the 3 rivets on my pack, simply for looks. my proptronix lights are screwed into wooden dowels that are epoxied onto the inside wall of the powercell.
As I’ve been super-obsessed with aiming at GB1 I guess I missed some of the subtler comparative modifications for GB2.
Nice. In that case it makes total sense, and is very helpful - thanks! I too will probably end up just doing them for the cosmetics, but either way… good to know
What rivets did you use? They obviously aren’t the same as the large flange ones that do the main mounting…
Not really. those two are in different locations. First pic shows it about 3-4 bulbs up (1-1.5 inches maybe?) and the one below it shows a screw right at the edge.
I was just wondering if the different pack levels (hero, semi hero) had the board attached in different ways.
I know this is old, however I believe the correct size should be 5/32" with 1/4" range. I have both sizes in hand and the 3/16" seem to be slightly too large. Thoughts anyone?