Audio out Pack: Amplified Sound Board

Hi.

I have put 2 micro JBL subs, 2 JBL micro top end speakers and a class D JBL amp into my sons junior pack. They run for 6 hours on a small Nimh and they kick ass. Shake the pack of the chair.

My question is, does " Gbfans Pack: Amplified Sound Board " also have a mono audio output? Ie for those running their own amps.

Thanks Si :slight_smile:

Ps I’m using heavyprops full kit. Everything works great. Just no flashing barrel LEDs when you fire. My little boy is gutted so looking for different solution as Crix does not offer any support or help to customers.

Unfortunately, no… You’re going to need something like this to make it work (Have not tested it myself, but it should work for what you need, and it’s less than $10) - Amazon.com

Links in this post may be affiliate links. Purchases made through them help support this site at no additional cost to you.

How many watts are you looking for? The 10 watt on board amp is very loud and efficient.

You could potentially place an amp after the sound board output if you use a pre-amped input filter similar to the one pyhasanon posted.

This is very true… People can hear my pack overheat from across a Convention Center, and you can hear the sounds play during a loud parade as well (so, if you like playing music through an MP3 player via the board’s AUX line, it works perfect)… This, of course, is dependent on you having good speakers as well…

Thanks for the info I will try a RCA LINE INPUT OUTPUT HIGH TO LOW.

There is a speaker + and - wire and a ground wire on the Line Out Converter.

Does anyone know where you put the ground wire?

On the Negative Out on the speaker out?

Thanks Simon :slight_smile:

Links in this post may be affiliate links. Purchases made through them help support this site at no additional cost to you.

Hi.

It’s for a junior pack (60%). So I’m using ultra small/light weight JBL subs and speakers which pumps out sound from a miniature lightweight Class D JBL amp and 3.6v Battery. It is rated at 15w RMS. At the moment I’m using the Heavyprops light/sound kit but it has no LEDS for Barrel lights that work correctly. So I’ve ordered a GBFans sound/light kit. Was hoping to tap from audio out before it reaches the amp part of the circuit.

Thanks

Simon :slight_smile: