Eric Gentry
Salinas, Ca., USA
Price: $300 + 50 for domestic shipping
Hey everyone! I’ve been away for a while, but I’m back on unemployment, so you know what that means! SHELLS!!!
Just in case you aren’t familiar with my shell, here is the original build thread showing how I made my mold: Constructing the E-Ticket Fiberglass Shell, MOLD COMPLETE!!! - Proton Packs - GBFans.com
As you might remember, this shell features MANY updates from Stefan’s plans, and is as screen accurate as I’ve seen.
This particular shell has a few air bubbles, which is why I’m selling it at a reduced price,but definitely nothing that couldn’t be fixed without too much time invested. I did my best to accurately depict the flaws, using absolutely horrible outdoor lighting to really make the flaws stand out.
Here she is:
As you can see, there are 3 raised air bubbles near the bottom/middle left cyclotron, which will mostly be covered by the bumper.
Here’s a closer view of the cyclotron bubbles.
There are also a few really small air bubbles on the PPD, but those will be totally covered by the booster tube when you install it, so they don’t matter at all.
Here’s a pic to show how the shell fits to my custom aluminum motherboard. The motherboard will run you an additional $50.
And, here’s the custom water jet cut motherboard all alone:
Like I said, if you would like the motherboard as well, that’ll be an additional $50. If you would like me to drill the n-filter holes drilled for you, that’ll be an additional $10. So, for the shell, n-filter holes drilled, the motherboard, and shipping the total would be $410.
PM me if you’re interested or have any questions. Thanks!