I was curious if anyone knew the proper nut size that would fit the hat lights on the proton gun. I don’t have the socket for them, but I plan to just attach it to the gun using a nut and fishing the LED into it. I figure that would be a cleaner solution than epoxying it in permanently.
I don’t know the size but this should have what you need.
Not sure what thread size it is however, the sockets give a much cleaner look overall.
You can drill the bottom of the socket out to fit a 5mm LED or I also sell midget flange warm LEDs that allow you to keep the socket intact.
A nut doesn’t exist. Its made to match the socket. Most other light caps use more standard thread, not those.