It was being sold as a Dissecting Scope and came in a blue box as do many Mirax Laborec products . I am sure that this is a Mirax Laborec Adapter! The instruction manual included was for the right Lens/Adapter.
The thumb screws it came with are exactly what was used for Rays Ecto Goggles in the movie. There must have been another laborec Camera part the Prop Department took the screws off for the right Lens!
Gah! I was desperately trying to dig up where the other lense had been identified, to make sure the previous announcement wasn’t for a lense of the same design. Thanks for steering me to the right spot, Fifth.
And on that note, here’s the page for the other lense part: Link
Glenn, thank you so much for posting pics with the ruler over on your facebook page.
I’ve started to 3D model a simple version based on your measurement pics!
Its still a work in progress, I have to work on the knurling in places (the chrome ring should’t be showing through the knurling).. but I’d say its like 90% accurate. There’s some small built in rings that the ‘nubs’ are a part of but I didn’t include those yet. Suppose I could integrate that into the model.
I would LOVE to 3d Model the Laborec Microscope adapter / Right Lens that you have, if you could post similar photos with the ruler of that I would be so grateful!
Looks great to me! Great find Is it ok if I add you on fb so I can check out the pictures? Also did you have any picture of the box it came in or a model number??
Yea, I can look on my computer for it. We would need help from some of the 3D modeling experts here, as I don’t think the file / model is printable as is. There would be some maintenance needed.
