Looking to start my first pack

Who’s mobo is that, because you might have difficulty fitting that mobo with one of Nick’s shells will be tough.

Thanks for the input by guys. I think hero is a good way to label this thing for now, based on your info and what I’ve been able to look up. Since everything is resin right now, down the road I’d like to swap out for aluminum parts and real resistors and clippards.

The mobo I found on eBay and it is cut to Stefans plans. After doing some research a bit back it may not fit to the shell I’m getting. I will see if it can be modified to work with the shell or I’ll sell it and make one out of 1/4 inch plywood.

Fingers crossed for ya with it fitting. Aluminum mobos look so amazing :slight_smile:

so my kit has finally arrived from Nick-a-tron and these parts are just amazing! I’ve already started the build and I will most likely start a build thread to cover it(as soon as I can figure out how to upload photos again). Just a few things I need to figure out so I can really get moving, that hopefully you guys can help with out with.

First, the mobo I bought just won’t match up to Nick’s shell at all, sadly. So it looks like I’ll be making one out of 1/4" plywood until I can get an aluminum one from Nick. Has anyone made one out of plywood before? It does’t look too difficult I’m just wondering if anyone has any tips.

While drilling some of the holes for the various fittings, I managed to chip the outer layer of the shell. I was thinking I could just use Milliput like bondo and fill in the chips and sand them flush. Anyone ever use that stuff for filling in chips or anything? Or can someone recommend something better?

Lastly, the shell sags a bit down the center, Nick says it from the original he used to make the molds, however because of that, I’m having a issue getting the Ion arm to sit flush against the shell and look straight and how to get it to mount without the worry of it breaking off since it’s a hollow resin one. Anyone got any ideas/tips to fix this?

any help/advice is greatly appreciated!

Plywood has been used. Although, I believe the general consensus uses MDF for the mobo as it maintains a smooth surfaces. With MDF, you need to seal it before you paint it or there’s a likelihood of it swelling from the moisture draw.

Milliput will work just fine for the chips. I used apoxie putty which is the same thing for the most part. If you do it right, you might not have to sand it ^^

Started a separate build thread, go check it out!