Mounting the speaker? Tips or tricks

I’ve seen where a lot of people have mounted the speakers for there sound kit facing out on the motherboard, some with holes drilled, a few with screen over it, and I was wonder what was your favorite and or best method?

Also side question for the one who have done the drilled holes in patterns over the speaker what did you use as a template?

Sent from my MT-500 using Tapatalk

I had the speaker both ways. Originally facing in, but the sound was extremely muffled when I was outside or around alot of people. So I took my speaker (5x7) and created a photoshop template using the oval tool and then I pulled guides from the ruler and spaced them out evenly them used the brush tool to make a 1/4in dot on all the intersections. I taped it the me mobo and drilled away. Flipping the speaker by far doubled the loudness and clarity of the sound!

I’ve got one each way in my pack, but no grill drilled out in the motherboard yet.

It’s pretty damn loud right now, but I haven’t taken it out and about yet. So once I get a “field test” done at some point I may add the grill in the motherboard.

I’ve got 4 facing the mobo, and one facing outward, in the N-Filter.

Mind showing how you did yours?

Sent from my MT-500 using Tapatalk

Sure!

Here’s general placement. 2 piezos up top, and two 3-way speakers in the sync gen:

Finally, in the N-Filter with one of those little speakers from an old IBM case, for rear sound projection:

I need to take more recent photos of this setup as they’ve since been bolted in and wired up, but there ya go.

Has anyone tried to put a tiny speaker in the thrower? I don’t suppose there is any space left after lights, and zero left if there is a barrel extension.

For those with sound in their packs, it is weird for all the sound to be coming from the pack?

this is a really good question all thing’s considered, BUT is there enough room in the thrower for a speaker; even a small one?

Maybe a small tweeter but Idk if the sound quality will be enough to stand out against the pack

Dbl post…

I think I could likely fit one in my thrower, but it would have to be small - like no more than an inch and a half in diameter - and at that size, it couldn’t compete with the larger speakers, and may very well get blown out at the volume. I suppose you could wire in a trim pot to reduce the volume going to just that speaker, but really, it’s probably not worth it.

It’s definitely not weird having just the sound come out of the pack if you have a good, loud system.

Haven’t mounted a speaker in a while… getting pretty lonely.

:smiley:

I had a speaker in the thrower but like everyone said… You can’t really notice it… Just added more weight.

Sent from my GT-I9000 using Ghostbusters Fans on Android