Nolatron's Ecto Goggle

Recently finished up my Ecto Goggles so thought I’d finally post 'em up to share.

The frames are AN/PVS-5A NVG frames from Vincenzo330’s Reject Frame sale. Here’s what they originally looked like.

The plate and lenses are resin and came from mikenelson1982

I got the lens knobs off Amazon. Just had to cut off most of the threaded part, but they worked perfectly.

Black Side knobs are from the GBFans Shop and the Headstrap from JoeLune33.

Everything was primed with Rust-Oleum automative primer grey. Frames were painted Krylon Camouflage Olive, the lenses got a coat of Rust-Oleum Satin Black and the tip of the right lens is Rust-Oleum Metallic Silver.

Decals are just printed on label paper. Really would like to do some foil type labels or some vinyl. Something that doesn’t look like it was printed on a crappy inkjet.

Still need need a facepad for the inside. Since the on/off switch on the bottom actually works I might try and see if I can get some kind of lighting to work on the inside too.

Some epoxy also got on the top left of the frames (you can see it in the first photo). So not sure if that’s removable at all without pulling off the paint.

Links in this post may be affiliate links. Purchases made through them help support this site at no additional cost to you.

The side label is white not foil. So I wouldn’t worry about that. Those goggles kick ass either way.. :cool:

I grabbed some “kids foam” from Michael’s for a gb1 style facepad. You could also use weather striping which I believe is accurate.

Yeah, foil isn’t the right word. Vinyl probably isn’t either. It’s some decal material that’s not thick like regular paper labels are that, like my bobamatt labels.

Dude, amazing job! They look great and I actually think the epoxy gives them the “used” look. Unless you want them to look brand new I would leave it.

Sent from my MB860 using Ghostbusters Fans on Android

Water transfer paper. I got some off of ebay. Practice withal sheet first since you need to coat each page with clear.

Sent from my DROID X2 using Ghostbusters Fans on Android

Oh, and great job! They look amazing!

Sent from my DROID X2 using Ghostbusters Fans on Android

Nice job on the straps, good work!

What did you do for the inner and outer plates?

The plate is a single resin cast from mikenelson1982 here: http://www.gbfans.com/community/viewtopic.php?f=31&t=29387

I epoxied it in place and then filled in the side gaps with some apoxie sculpt.

Ah okay, so just a single plate. Hmm.

Yeah. The lenses are epoxied right to the front of the plate.