Proton Gun V2.0 build thread

image

Basically you need to drill two small holes on the top of the gun, the size of the threads for the light and the switch. On the bottom side you need to drill a large hole through the back of the light and switch holes, but don’t drill this hole all the way through. You need the larger hole so you can fit the body of the switch inside. Once you got that done, you want to drill a smaller hole (big enough for the wires) through the right side of the ear, through the two light/switch holes, and into the barrel. After that, just run the wire, fill the little hole and hand paint it black.

wow you have a diagram and everything

thanks very much for the info

the gun Kit I ordered from you arrived yesterday and wow you do amazing work

Im very happy with it and I cant wait to get to work putting it together

thanks again

Opps, thank god for the nut to hold the screw in place

Oh yeah, you can do that too so long as the hole is the same diameter as the push button. Just glue it into place.

TC do you by any chance know the diameter of the piece you used for the silver collar/insert ?

I can’t find my precision ruler but according to my yard stick it is 1 1/8"

Thanks for that :cool:

how long do the handles need to be and can you us how you made that cut

Which handle?

I should have been more specific. what should the length of the pvc pipes be.

TC, I love the paint job on that thing! Did you clear coat it, or was the Rustoleum flat black the last thing you hit it with?

I don’t really even measure the front one anymore because I just use my cast to mark where I need to cut it. For the rear, pretty much the length of the gun from the back of the handle to the edge of the Clippard Valve wall, minus 1/8" to accommodate for wall thickness.

There is a little flat Crystal Clear on it, but that was only so I could seal some of the rust I applied and my rub-on transfers. None of that has been photographed yet, so if you are going for the look in the photos I suppose just skip the Crystal Clear, or make sure to get a Crystal Clear with a finish that matches what you are going for.

So when will they be ready

Hey TC what silver spray paint do you use? you had me fooled on those gun knobs and trigger tip i thought they were machined, no matter what silver chrome paint i find i could never get the “wow those look like real metal” when i look at them effect.

The knob on the top is metal, as is the trigger tip. The best paint is Spaz Stix Mirror Chrome over a high gloss black finish.

Well That awnsers my question

You can make the rings on your own with a soda can.

can you show how you did the light below the bargraph

The Slo-Blo light?

yes and how about a step by step guide