Proton Pack Tubing Question?

Equipment Proton Packs
1

Hi all, i just recieved my tubing kit from MMM today, and was just wondering if you all could help me as to where each end connects to, and how long the parts should be?

also i have recieved two (2) red tubes, one is a smaller diameter than the other, so dont want to get these mixed up

thanks

Gary

2

http://www.gbfans.com/equipment/proton-pack/part-names/

Someone else may want to confirm but I believe the thicker red goes in one injector alongside the blue tubing(the two pipes coming out of the power cell(blue light bar) and also inside the thin split loom going from the HGA to the beam line(?)

The thinner red is used for the end of the proton gun and the two sections of red tubing going from the PPD(the middle of the pack) to the legris elbow on the cyclotron and also to the HGA

Man that’s a lot of technical mumbo jumbo. I better look over it before I hit Submit haha :sigh:

I think most people just use the reference photos to kind of eyeball how long they are and check it out before cutting to see how loose or tight you want it to look. There may be exact lengths some people use though! :whatever:

3

thanks:) does anyone have any photos of their own guns ect, so i can see where the tubes come from and go to as i think i am still missing parts from mine and not sure where their supposed to go to / from

thanks

4

Why not ask the guy who sold it to you? :stuck_out_tongue:

5/32" red on the gun tip from banjo to banjo

1/4" green on rear instrument bar of the gun from clippard barb to barb

1/4" blue from PPD to RH-50 resistor and from RH-50 resistor to top of Ion arm

1/4" yellow from small resistor on ion arm to Legris elbow on ion arm

1/4" Blue and 1/4" red on injectors to cyclotron base

5/32" red from Legris elbow on Cyclotron to Straight fitting on side of PPD(some people use 1/4" Red here )

5/32" red from PPD to HGA Legris elbow (some people use 1/4" Red here)

5

lol. because i knew you’d be on here somewhere. lol

thanks :smiley: i dont have all parts needed to fit them yet (e.g ion arm ect) but will hopefully get it done soon and in the right places. hopefully!

thanks

6

Why does the GBFans shop sell 1/8 yellow tubing when we need 1/4? is the 1/8 used on the trap pedal?

7

Irri has that wrong.

1/8" yellow is required on the Proton Pack.

8

Infact I’ll fix this a little bit.

4mm (or 5/32") red on the gun tip from banjo to banjo

1/4" green on rear instrument bar of the gun from clippard barb to barb

1/4" blue from PPD to RH-50 resistor and from RH-50 resistor to top of Ion arm

4mm (or 5/32") yellow from small resistor on ion arm to Legris elbow on ion arm (some people use 1/8" yellow here)

1/4" Blue and 1/4" red on injectors to cyclotron base

4mm (or 5/32") red from Legris elbow on Cyclotron to Straight fitting on side of PPD (some people use 1/8" Red here )

4mm (or 5/32") red from PPD to HGA Legris elbow (some people use 1/8" Red here)