QUESTION ABOUT HOLDING THE particle thrower ON BELT

Hi Guys, As some of you know, i´m , building my pack (ecuadorian pack) . This week i´ll be building the gun, and i need to know if there is a clip or a hook somewhere in the body of the gun, that is supposed to go into the belt thingy… The guys at braxtan film “GB vs Freddy” had a round metal thing on the base of the grip (looked like a key chain) , but i think in the original packs they had something else.

If someone could give me some directions on this… or better yet, a picture…would be really great!

Thanks a lot.

Sal

I don’t have any pics, but the real guns had a round hook (kinda like the hook of a coat hanger, but smaller) attached to the rear disk on the “gun track” on the bottom of the gun… Damn, that probably doesn’t help with out pictures. :?

johnny’s got ya covered e_s

image

image

how’s that? its basically like the S hook of a rubber tie down, or thats what i used atleast

Thanks man! I knew I could count on you! :smiley:

Man! I sayed it before and i say it again!

YOU GUYS ROCK!!!

(sorry for the caps but i think it was worth it!)

Thanks a lot guys… I´ll post completed pics once i´m done.

Sal.

By the way, those are pics from the real movie costumes? Where did you take them?

Sal

yes they are. i didnt take them though. aj had a section on the old site of reference shots and these were taken by some one at a planet hollywood restaurant. i saved them to draw the red circles on for a thread similar to this one a while back.