Question about washing a jumpsuit

ok, DUMB question, but… I need to wash my jumpsuit. The problem? I have a resin hose connector sewn onto the leg. What do you recommend? I was thinking of doing a cold wash with a few towels so the resin connector isn’t smashing up against the drum of the washer and dryer, but I’d love to hear what the rest of you do.

Maybe it might be worth un-stitching.

Turn your flight suit inside out and put it in a sealed laundry bag (have the zippers pulled up); wash it in cold water with a gentle cycle (to protect the patches). Just let it drip-dry instead of putting it in the dryer.

Of course, you can always hang it outside for 20 minutes like Venkman does (as there are many subtle layers of laundry…)

important safety tip, thanks egon…

seriously though, i wash mine in the washer by its self. and i also dry mine in the dryer. i have a G&B suit and a nomex, both have hose connectors. as long as ur stich is good it will hold. so.. anyone wanna play parcheesi???

What about the rubber hose connectors? As in the connector is made of rubber. I can see those being screwed up in the wash. I’m thinking dry clean only. Or would even that be no good?

ok, success on the official first wash. did a cold wash inside out and set the dryer to delicate and low heat and came out fine.

dtblack, I HAD a rubbed connector and the stitching tore through it.

What do you mean, in the wash or just in general?

well, it was tearing through normal use, but putting it in the wash was the finishing blow.

I attached mine with industrial strength velcro, that was I can just take it off to wash.

Why not just hand wash it gently?

You mean we’re supposed to wash them? Hmmm.. maybe thats why mine smells so bad… :smiley:

I just have mine steam cleaned.

i do it naturally. in the river, against a rock.

Old thread is old, but I recall a trick for washing fragiles is to put it in a pillow case, then wash that.

I’ve never tried it though. And I wouldn’t dry it that way.

I just turn mine (Nomex) inside out and zip it back up. That way the patches don’t snag and my resin leg hose clamp is better protected. Wash on COLD, turn it right side out and let it air dry on a hanger. Two years of this and no problems.

image

That is all…

I have a Khaki G&B, I take it to the dry cleaners. It has a resin Leg Hose connector right now, I am replacing it with a rubber one soon. The people at the cleaners said it is not a problem to clean.

If I had to wash it at home I would put it in a old pillow case. Then wash it on a Hand Wash or Delicate cycle(if your machine does not have hand wash). I would also not use any fabric softener. Then just hang it to dry.