So, at this point, I’m definitely planning on putting lights and sounds in my pack. As I was about to buy the 3/4 inch splitless tubing from the shop, something came to mind. because I’m putting lights and sounds in my pack, which requires a wide cable to connect the pack lights to the wand lights, I realized it may be difficult to get that cable through the splitless tube. While I don’t want the split in the tube, is it required to run the cable through it, or is getting the cable through the splitless tube no problem? Asking anyone who’s had experience.
If you are using the GBFans kit ribbon cable it’ll fit, what I did was take a coat hanger straightened it as straight as possible on one end made a hook shape the same width as the connector on the ribbon cable long ways, and a loop on the other end, I tied some paracord around the loop, and fed the paracord through. Then Taped the holy jesus out of the connector on the ribbon cable in the hook on the other side of the hanger. then pulled it through. You will need to twist up the ribbon cable to get it started.
hope that made since, but it will fit in the loom long ways, but you have to pull it through you most likely wont be able to feed it.