I cannot figure out how the hell to run the wiring for the hat light and secondary fire switch to the front of the thrower. I’ve looked through multiple builds and haven’t seen how they are wired. What makes it difficult is that I have a manual extending and twisting barrel. If I have to I can just make it so it so the handle doesn’t rotate anymore. I really don’t see the point of it anyway. Please help I’m stuck! Thanks guys!
You mean these wires?
Yes sir. Since I posted that question I discovered that there is a separate section for throwers in the forums but I could not find how it is wired when the barrel twists and extends. The way mine is set up is that you have to manually extend the wand which is a pain itself, but I suppose It would protect it from breaking off if its retracted while its holstered on the pack. I suppose you could run the wiring under the handle but I would have to cut a channel on the inside of the handle to run the wiring through. I would have to do it off centered though because of the screws that hold the handle to the thrower. I don’t see the point of the twisting barrel so I could keep it from turning with some hidden set screws or something. That seems like it would make it a lot easier to run wiring. As far as how the wiring goes into the gun box do you just cut a small hole and maybe fill it with putty after you run the wires through? I will take any suggestions! Thanks!