Which lights?..

Hey guys,

I’m looking at a custom Spongeface sound kit and need a light kit but there are a few pre requisites.

  • I need a light kit that has basic light activation (no sound)

  • A secondary vent light activation, this I want to couple with the power up effect.

  • firing and wind down sound coupled to barrel lighting

  • light kit needs to accomodate for barrel extension internals

  • Gb theme incl on the soundboard

What are my best options?

Cheers!

Id go with one of the trusted sellers on this site… GBfans lightkit, prop forge or crix lights will do all you want and more.

Any of the kits can be tweaked to fit in your pack to allow more room for a acrylic tip extension …

So they’re all tops, good to hear. I had a full Mighty rig but don’t trust it for hassle free ghostbusting.

Which of those give the best wand flash and wand vent lighting in your opinion?

I have a mighty and love it but if I did it over I’d get a GBFans kit. It’s so much easier to wire up (are are propforge and Crix’s kits). You can’t go wrong with any of them on the site. I BELIEVE they all use a 2 or 3 LED set-up for barrel flash.

Alright cheers for that . Are propforge or crix the latest?

Propforge is the newest addition I believe. Check the for sale section, all your answers lie within.

I don’t currently possess one, but I plan to get a PropForge light kit as it’s the most accurate (to what’s seen on screen) light kit out there.

The GBFans kit has one single RGB LED for the tip firing. You can also get an expansion kit from Spongeface that adds more / more powerful LEDs.

That’s not really an important metric.

Crix had a wand kit out there for a long time, then the GBFans kit, and then Propforge. I wouldn’t say any one is better based solely on which is the newest model. Others such as Proptronix, Hyperdyne and R2DEVO have had kits out for a long time too, none of them are worse for being older than another.

Usually as new ones are released, improvements or newer accuracies are made was my logic.

Thanks for your advice though, will probably go Propforge because it’s for a Spengler gb1 hero.

Any tips on light and sound combos with barrel mech? I went for Prop Forge lights since it allows for barrel extension room. I like the Spongeface basic movie sounds. Issue is getting the whole lot to fit. Firmware extending the GBfans soundboard to pack is not recommended.

Have any of you mated Prop Forge lights with Spongeface sound and a barrel extension? Or what other options/ sound kit would do the trick if no?

I was the one that designed the Prop Forge Lights. If you check out the build thread of my “Stantz” Pack, you can see how I have the electronics installed along with a GBFans sound board: Click Here

The idea with the Prop Forge gun lights is the larger, driver board is mounted on your motherboard somewhere, and then a ribbon cable is run up the split loom to the wand, where a small board has all the lights and switches connect to. The GBFans sound board would still connect to the main driver board, which would be on the motherboard, as seen in my build thread.