is there a tutorial on how to wire up the shop supplied power battery to the pack lights? ive been looking online and zippo.
On the powercell/pack light board there is a blue block with two set screws. It is marked as “Pos” and “Gnd.” You would need a stretch of wiring with bare ends on one side and preferably an adapter to connect to the blue brick otherwise you would have to cut off the male end of the battery. Not sure coming off the battery which wire would constitute the positive or the ground though. I am using a Spengler plate with wires (courtesy of NStevic01) to connect the brick to my Matty Blaster soundboard but the bare-wire hookup would be similar. GBFans.com
After I posted I noticed that the item in the store has a link to the documentation: https://www.gbfans.com/images/shop/packlightinstructions.pdf
Hi! Sorry to hijack your thread but is this something that I would need to connect the 12v battery to the soundboard? Amazon.com
Links in this post may be affiliate links. Purchases made through them help support this site at no additional cost to you.