hi, i’m new here, and i was just wondering if you guys knew a way to mount the frame on when all the other stuff has been put on. btw, I can’t take the stuff off, I used gorilla glue to put it on because i thought it would be easier than nailing it on.
thats a good question. wish i could help you out but i’ve got nothing. good luck
Wouldn’t it just be simpler to use L-brackets, nuts and bolts? That way you can reuse the frame for future packs.
I forget what it’s called, but I used strips of that stuff plumbers use to hang pipes from the ceiling. It comes in rolls, is usually gray in color, and is basically a long strip of plastic with a hole every 1/2 inch or so. It’s thick enough to support a load but thin enough that you can cut it with a good pair of scissors or tin snips. Like Terrace’s method, its easy to take off these strips if you ever decide to build another pack and want to reuse the frame.
Interesting idea, Radar. Got a picture of what you’re talking about?
i like that idea but my idea is to use those nails you hammer into the wood and you screw the other piece its connected to to tighten it, but the tightening nail keeps getting loose, so i’m probably gonna gorilla glue it to the wood, and if that doesn’t work, i’ll try those strips you were talking about.
thats a good idea radar
they are called Pipe straps.
In a pinch, you can also use zip ties. The 3/8" wide black industrial type.
I didn’t use the pipe straps. i did my idea and it worked perfectly. thanks anyway.
post pics!
i will when i’m done with it.
Well, not sure what I can say, but I’d say that you can drill through the frame and mount it where you can get at…or cut access holes to get at what you can’t get at in the motherboard. When it’s on your back, nobody’ll notice.
This is what i would do
-
Cut a hole in your mother board big enough to fit a nut into (You will have to use your ALICE pack to line up to mark and drill the holes in the right place)
-
Cut a square piece of wood that will be big enough to give enough surface area around the hole to give strength when glued on. Cut a hole in this to allow a bolt to pass through.
-
Drill a hole through your ALICE pack frame cross sections in the correct place
-
Glue the Nut into place on the extra piece of wood so that it doesn’t turn when you tighten the nut
-
Glue the extra piece of wood into place (some extra glue into the hole of the motherboard may help the nut stay in place when the bolt is tightened)
-
Place the bolt through the ALICE frame and then screw another nut onto the bolt from the other side (add more depending on how far you want your ALICE frame to come away from the pack)
-
DON’T tighten these nuts yet as you now have to srew the bolt into the nut you have glued into the pack and they will tighten on their own (You may have to keep loosening them until the bolt is tight into the nut in the pack then you can tighten them to clamp the ALICE frame tightly)
Sounds like a lot of instructions but hope it is of some use, here’s a basic diagram
That’s really helpful, thanks man!



