Hello, my name is John, I have 3 sets of aluminum trap plating for sale. 1 set is pictured below, all sets are made the same. Im shipping from Toledo, Ohio. PM if interested.
-$40 shipped inside the US per set.
Will these fit a benofkent trap kit?
Sorry for the extremely long delay on an answer, didn’t get an email notification for the thread. I’m not sure if they will, if his traps run small like his shells they might not.
Can you provide some dimensions the panels? Also, how thick are they?
Sure, here are the main plate measurements that will probably matter most for you on sizing.
Side plates = 8 1/16" x 2 13/16"
Front plate = 3 1/16" x 2 11/16" (at its highest)
Bargraph plate = 2 1/16" x 1 1/16"
I can’t find my calipers at the moment, but when I do I can give you a thickness.