Assembly tips: working with foam and puttying...

Anyone have tips of working with insulation foam? Better to use a rotozip/dremel, or a jigsaw?

Also, what do you use to putty it? I know wood putty dries hard, but foam has some give to is.. is a paintable latex caulk better, or is there something else that can be used that won’t eat the foam?

Tips learned the hard way:

  1. I’d use a razor and/or a jig saw for your cuts. Both work fine. When working with the razor/box cutter, work slow and do multiple pass cuts instead of one deep cut. Deep cuts tend to shred the foam. Change your blade frequently, it will dull faster than you would expect (also, wear leather work gloves until you get comfortable with the box cutter, you’ll save yourself some pain).

  2. Wood glue works great to adhere foam to foam, make sure you give it sufficient time to dry and use it sparingly

  3. Want to reinforce a piece, e.g. the ion arm? Use a sharpened pencil to poke a hole in the piece, than push a wooden dowel in through the opening

  4. You can use hot glue to attach the foam to wood or pvc. Use it sparingly and apply the hot glue to the wood or pvc FIRST, let it cool for about 5-10 seconds then attach to the foam.

  5. Don’t use wood putty, it will melt the foam. HOWEVER, spackle works great and can be sanded easily (it’s cheaper too)

  6. By a big jar of Modge Podge and cover all your foam pieces liberally with it before spray painting -it should keep the foam from melting

  7. When spray painting, use multiple light coats. If you spray heavy you get drips and will increase the probability that the paint will work through to the foam and start melting things.

Good luck, have fun, and may the force be with you :cool:

Great tips, and THANKS! Just tried my old jigsaw, and it’s VASTLY better then a a roto cutter, is easier to control, and gives you much cleaner cuts.

I’m going to repurpose my dremel roto cutter synchronious generator parts I did yesterday, and redo them with the jigsaw instead. That should reduce cleanup time. Fortunately, I still have the pattern I made for them.

I’ll also pick up the spackle as well. Rather then spray paint the foam parts, I’ll be paint them with latex house paint. It takes longer to brush point then spray, but the house paint is thick, and a few coats will give the foam a more durable surface.

I’ve done smaller projects with foam before, but never anything this big, that might get some abuse.

Glad to help. I’ll be following your progress with interest. Make sure you reinforce the bottom of your pack -it takes a beating (cause that’s what it sits on when you lean it against a wall). I’d suggest cutting wood plates to run across the bottom and coating the whole bottom in Grip Dip.

Read that advise before, and was planning on using wood for the bottom detail panels. :wink:

I’m also making the bumper from wood as well, since I figure it’ll take a beating as well.