Been working on this on and off for a year. Next year will be a proton pack. I finally got the patches and leg hose etc finished to I tossed everything on, and turned a flash on in my kitchen to snap a couple shots.
Went for a mix between accuracy and cost effective.
From head to toe:
Ecto goggles made from welding goggles, store bought LED lights and circuit stuff, lenses made with found objects lying around the home and work.
Uniform from a local army surplus store in toronto (same with the belt which is actually an army green in real life)
Patches from the GB fans shop
Volleyball knee pads for elbow pads, dyed with RIT.
Key fobs from found chain wallet clips and other bits
Matty PKE
MDF trap with hand cut metal plating, led light sequence from jupiter electronics, other knobs and stuff from an electronics surplus store in Burlington. Vector plate and resistor (not pictured) from the GB fans shop. And yes I know I’ve got a missing trap knob. I haven’t found the right one yet.
Trap pedal with hand made MDF base, real hammond project boxes, LED light and Relay from same electronic surplus store. Vector plate, ribbon and ribbon connectors from the GB fans shop.
Leg hose stuff is from Home depot. Clear tubing died with yellow RIT dye.
Not pictured: Two different tape measure holders for the PKE and belt gizmo, which consists of a computer chip, led lights and wires soldered on.
I think that pretty much does it. Thanks for looking.