Charlesworth Dynamics Trap Build

Equipment Ghost Traps
23

Thanks for the recommendation. I’ll have a look at those. Now I’ve got the parts for the trap printed I’m gonna look at printing the bits for the pedal (the parts I want to 3D print) and then I’m going to buy all real parts for the rest of it. Already started as mentioned before with the 11 pin relay. Just trying to find the bits as cheap as possible as money is kind of like goldust at the moment. Not got much spare at the moment.

24

Just looking at the lights for my trap. I know on the list it says Adafruit 2860 but would these do the job https://www.ebay.co.uk/itm/252067161443 ? I’ve got these in my proton pack for the cyclotron lights and the wand light too. It also uses the Adafruit Neopixel library as well to control them.

Regards,

Brett

25

Would these Hinges be OK? https://www.diy.com/departments/chrome-plated-metal-butt-door-hinge-n429-l-50mm-pack-of-2/256917_BQ.prd

Do they fit the Vector plate used for the pedal from CD kit or did you use your own Vector plate and drill your own holes in it?

Only two hole hinges I can find either in 38mm or 50mm sizes.

Regards,

Brett

26

It looks like they may have changed that hinge, as that is the one I used according to the link I had saved (albeit zinc plated), but it was 4 knuckles not 3 when I bought it. I’m sure that would work fine though, you may need to re-drill the holes in it though, depending on how the line up with the vector plate holes - I had to do this, and it was fine. I could tap enough of the new hole, and used nuts on the rear, and it holds with no problems. I used a real vector plate on mine, rather than a 3D printed one.

27

https://www.diy.com/departments/timco-solid-drawn-brass-hinges-satin-chrome-50-x-28/5056110823195_BQ.prd

This was the hinge I used. Only available online from B&Q it seems oddly.

28

Hi All,

I’ve got some split loom tubing for the trap to pedal hose. I got 8mm tubing with 1/4" inner diameter. However, it doesn’t look big enough to me

Does anyone know what size the outer diameter tubing should be?

Thanks,

Brett

EDIT: BROUGHT SOME MORE THAT IS 10MM O/D AND 6.5MM I/D. A review said that it is the exact size needed if building a ghostbusters trap and pedal.

Mintice Corrugated Hose for Cars Split Loom Wire Insulating Protective Hose for Electrical Cables Wire Flexible Tube Cable Management Organiser Diameter 10mm, 6 Meters Amazon.co.uk

Links in this post may be affiliate links. Purchases made through them help support this site at no additional cost to you.