Circuit Board Attachment

GBfan37830 · January 21, 2009, 9:22pm

Hey guys, I’m working on my circuit board. I was wondering on how to attach the smaller circuit board to your belt. Thanks.

Zack · January 21, 2009, 9:38pm

I dunno about other people, I glued my smaller circuit to the belt holder clip backing of a dollar store cell phone belt holder case.

irricanian · January 21, 2009, 9:47pm

This is what I use

http://www.tandyleatherfactory.com/home/department/Hardware/1238-00.aspx?feature=Product_17

Should be able to find the equivalent at most key cutting shops or maybe a hardware store.

GBfan37830 · January 21, 2009, 10:05pm

Thanks guys, I appreciate it!

exo95er · January 22, 2009, 3:34am

A bolt, washer, and nut. Drill a hole in the circuit board, and thread through a hole on the gun belt:

Dr_Spengs · January 22, 2009, 9:28am

I hot-glued a little office depot magnetic clip I found at work onto the back of mine.

Goosebuster · January 22, 2009, 2:23pm

I made 2 small holes in it and threaded a tiny black zip tie through them and the holes in the belt.

Crix · January 22, 2009, 8:07pm

I used some sturdy velcro on mine.

AZspidey · January 22, 2009, 8:55pm

I just looped a piece of strapping and glued it to the back of the board. Kind of like a belt loop and then just slid it on the belt.

GBfan37830 · January 23, 2009, 11:46pm

Thanks guys, I appreciate everybodys info.

Crix · January 30, 2009, 4:12pm

Erm, I mis-read the question apparently, I used velcro to attach the main board to the holster, but the small board on the back was attached using a metal clip off a $0.99 tape measure, bent open a bit to handle the thickness of the web belt, but it holds on great.