Hello all! As some of you know, I recently acquired a used Proton props 84 pack. Unfortunately, the post office was not at all gentle with her, and caused significant damage to the wand.
I’m working on an insurance claim, but I am having trouble figuring out prices.
The wand needs to be either replaced or have a complete overhaul.
Any of you who have sold wands in the past, what do you feel a wand of that caliber would cost to replace?
Are you talking a fully built wand? If you were to strip down all the parts from it to be reused (electronics, lenses, clippard valve, knobs etc) then you’d probably be looking at ~$200 for another wand kit, and then at least that much again for someone to build it for you. What specifically is broken on this one? Photos would help too.
It’s a mess overall: there’s definitely wires not connected properly, as none of the switches are working/work intermittently: sometimes it works sometimes it doesn’t. Sometimes it just goes into party mode, sometimes it’s a paper weight and nothing works whatsoever
The barrel of the wand is also not attached properly and continually falls out. The pop mech, because someone messed with the wiring, pulls on everything when released.
They should have a little barbed metal “sleeve” on the end of the wire that locks into place in the white plug that then goes into the socket on the PCB. You need a specific tool to put those on though, not sure what it’s called though I’m afraid.
I believe it’s a wire crimping tool, but I think it’ll be safer if I just pay someone to fix it lol I’ve never tried my hand at wiring, and I’m not about to give myself a crash course on my wand lol.
Here’s what I’ve figured out needs done thus far:
All of the wires on the wand board need to be recrimped into their pin connectors
Wiring needs to be properly housed in the wand so the pop mech doesn’t catch on it anymore
Spring in the pop mech may need replaced. Impossible to tell until the mess of wires is dealt with.
New M4 socket cap bolts for the bottom of the wand (the wand arrived missing half of them)
Touch up paint on the resin (I like the exposed metal but exposed resin kind of shatters the illusion)
Replace screw on banjo (missing)
Remove electrical tape from the exposed wires outside of the wand (can someone post pictures of their accurate wand. Are there supposed to be exposed wires? Or should everything be internal) here’s a picture for reference:
Once the shorts in the wand are dealt with, I believe everything should be in working order. Right now everything just kind of works sometimes, which I’m assuming is because literally every wire has a bad connection lol.
The only problem I haven’t addressed is the smoke kit. The pack was sold to me with the smoke kit not working. Part of me wanders if the kit that’s installed on it is fine, but all the other shorts are causing it not to work.
I’ve already purchased a replacement smoke kit, hoping someone in my ghostbusters group has the skill to install it!
Weird the banjo screw is missing, as they don’t really fall out easily. Those are the GBFans banjos, I don’t think AJ sells just the bolts on their own though, and not too sure where you’d be able to source one from. Maybe try eBay?
The wires with electrical tape on are fine, and were exposed on the real packs during GB1. At some point during filming they had a strip of gaffer tape across there, rather than electrical tape, so you don’t need to worry about that too much.