Exoray battery pack to MMM motherboard - won't stick!!

Hey all,

I’ve been trying to stick the Exoray black plastic battery pack to the inside of my MMM motherboard. I’ve used 2 part expoxy, 2 part JB Weld, and Gorilla Glue, but nothing sticks!!! The glue just won’t stick to the plastic, and doesn’t stick very strong to the metal.

I’m thinking about sanding the plastic, maybe that will make it a rougher surface for the glue to grip to.

Does anyone have any ideas? How did you guys do it?

Thanks in advance!

Definitely sand the plastic and rough up the metal. I would think that an epoxy or gorrila glue would work…it’s possible that the parts were just too shiny and slick for the glue to stick.

Mark the area on the motherboard where the battery pack will go then rough it up with coarse grit sandpaper then clean with spirits. do the same to the back of the plastic holder, glue needs something to bite into or permeate. Roughing it up should do the trick.

Those batteries are heavy man, why are you using glue? Nuts and bolts.

Nuts and bolts!

Exterior rated double sided tape, they sell it at the hardware store for attaching house numbers onto the houses exterior surface like bricks…

Or drill a few holes and use some zip ties…

If you absolutely must use glue, I believe Goop will solve your problem. Unless you use something that “melts” the plastic, you’re not going to get a good hold.

I modded my Halo3 tin case with some clear Plexiglas disc holders from a multi-disc DVD case. I trimmed it to fit inside the cover and used 4 dabs of Goop to hold the holder to the tin. It was the ONLY glue that held to both sides.

I think it was Marine Goop, in a blue tube. Its really strong stuff.

You can also drill holes and use bolts or heavy duty zip ties. Industrial Strength velcro might do the trick, too.

Have you tried superglue? I’ve found it bonds pretty much everything to everything, including my fingers.

Superglue doesn’t hold onto that type plastic either..

The type of plastic in (most) battery holders is sometimes referred to as “fatty”. (You can spot them because the surface of these often feels greasy, no matter how clean they are.) You will always have a very hard, if not impossible, time trying to glue them.

I would suggest:

  • screws (as has already been mentioned)

  • zip ties (as has already been mentioned)

  • making and mounting a holder/pocket on the motherboard and insert the battery holder there. This is mainly for those that want the batteries on the outside for a quicker change. This would also help those huge D-size batteries stay in place.

I love that stuff!

Used double sided tape. Works just fine.