I hope you’ve heard of my site. It’s just a small site for GB props. I wanted to ask Ghost Heads who have made Prints for Props. If they will let me use them on the site. If so, post a link to one thanks. 
Good start.
Nice site!
Thanks. Also, I been trying my best to fine correct names and parts but I’m haveing trouble. This is what I have so far.
Trap:
Trap Resistor.
Trap Pedal 9-Pin D-Sub housing.
Trap Wheels (ballbearings for skateboards–608ZZ)
20-pin Latch/Eject Header (gray base for 20-pin cable)
Raytheon Tear-Drop knob.
Vector plate for pedal.
V-Hook on bottom.
red and yellow tubing.
3/4" and 1/4" Split Loom.
ALICE frame
Dale RH-25 or Pacific CH-25 resistor (small one)
V-Hook on Gun.
Rubber-cushioned steel loop strap (3/4")
Uniform:
Tape Measure holster for circuit board.
Military pistol belt (canvas)
Keychains.
ESD coil for circuit boards.
Clear and yellow 1/2" O.D. tubing.
Paratrooper boots.
No-Ghost and Nametag patches.
If I missed any thing, or there’s something wrong, what is it. And does anyone know what parts are for the ecto goggles, P.KE and Giga Meter?
I suggest you wait until the new Ghostbusters Prop Archive opens.
It will have pages on everything you seek, and more.
Ok. Thanks man! 
I have thought about and thought about. It’s kind of dumb for me to have a GB prop site when there already is one. :lol: So I was looking around and I thought hey, why not a site just for Props, in general. So here it is, the new carbonpropping forum! http://carbondude.proboards78.com/index.cgi I would love to see some members!