Hey guys,
I’ve been going by Norm’s plans for my pack, but looking at any of the plans, I can’t find drilling dimensions for all of the light locations. Is this something that is typically eyeballed? Or does someone have hole location information for the wand? Thanks for the info.
Bryan
My images are from Sean’s plans, use Stefan’s plans for the locations, just print out his 1:1 plans and measure the locations…
So I’m guessing you printed it out on A4 and then just taped together the sheets?
Well, I guess I’ll have to buy some A4 paper…
Stupid 8.5" x 11"
You can print on 8.5 X 11, just make sure the “scaling” area is set to “no scaling” there is enough overlap on the sheets to get it working… Just make sure the final length dimension is correct…