Modifying SMC Elbows for accuracy?

Hey folks. I’ve currently got some standard white SMC elbows on my pack which I’d like to modify to look more accurate to the (impossible to find) Legris elbows from the original movie packs. Obviously, I can paint them grey easily enough, but in particular I would like to modify the push-fit end to remove the retainer/release tab, and put in a brass tube.

I see that some people have done this in other threads, though most of the threads are old and sadly the images aren’t available.

I was wondering if someone had/would be able to write a short guide on the steps (what to remove, etc) along with parts needed (diameter of brass tubes etc)?

Seems like something that should be *fairly *easy to accomplish but I don’t want to just start pulling them to bits and potentially damage them in a way that can’t be repaired.

You can literally just pull the push fit part out with a pair of pliers. You want 5mm OD/4mm ID brass tube to replace it, approx 10mm long sections. Little dab of superglue to hold it in place. Do that after you’ve painted, obviously.

Thanks that’s really helpful, and does sound very straight forward.