has anyone mounted a Alice frame with the original motherboard that comes with the pack?
and if so, how you did it?
You can use these brackets that GBFans member Spongefacemcgee sells on his ebay here:
this works well
thanks!
Also if you want a cheaper option you can simply zip tie the frame to the pack. A couple holes near the back side of the power cell and where the wand mounts, and utilize the holes on the bottom that are already there for the basic straps. If you use black ones they’re not noticeable in any way. The spirit pack is so light that the odds of it falling off especially with four or so of them, is next to none. I used two on each of the bottom positions myself. One going horizontal to the frame and one going vertical. Just to keep it in place as good as possible.
Edit: Forgot to mention that doing it this way left little room for access to the battery pack. All I had to do was remove a piece of the plastic to get it to set inside horizontally instead of vertically. Grabbed some photos in case you were curious.
