Hey folks, I was just about to close up my pack and gun before taking it out tomorrow. And before I did I ran one last sound/light test. and sure enough something is acting oddly.
I’m using the GBfans boards for both the pack and gun sounds and lights. But the pack board isn’t running the overheat effects. The gun is though, the bargraph and lights respond correctly when I’ve been firing too long, but on the pack the light sequence doesn’t speed up and the speaker doesn’t play the warning/vent sounds. I probably just messed up a dipswitch configuration or something…but I’ve double-checked and tried every config that should produce the desired overheat effect. I’m sure I’m overlooking something simple, anyone have any ideas?
Unfortunately movie sounds does not have an over heat sequence because that’s not accurate to the movie. Have to switch it to tvg setup on the sound board.
Sheesh, I even knew that, I must’ve flicked one accidentally. Then psyched myself out and started changing things and getting loopy, ah well. Thanks for helping the newbie man, all is well.
