Can some one direct me to any previous discussions about that? I don’t want to mount my alice pack too high nor too low
AJ, I am not sure if you meant to post that or if that was an error, but here is a thread discussing mounting the motherboard to the A.L.I.C.E. frame:
In it is one of the illustrations from Stefan’s plans that I think AJ meant to link to instead of the one showing the pack overview.
BTW, that took me only a few seconds worth of searching by entering in “motherboard alice frame”. 6th result down. Hope this helps.
I didn’t know you only need three holes. Thanks!
I wasn’t concerned about what position it is on as long as it looks good.
I hope the drill bit I got will be able to go though the Alice frame.
I have some cheapo drill bits from Lowes ($10 for 1/32 up to 1/2") and it went through fine. I wouldn’t worry about it. It’s only aluminum.