Advice on the thrower.

So I have the throwing chicken resin thrower kit and the ear on the front of the front handle is kinda ugly. The wires are sticking all the way through for the blast stream and the light. is this a common problem and if it is what have you done to make it a little better?

I was going to PAX east shortly after I got mine done so i just quickly put black tape over it to kind of hide it.

The wires should be fed underneath the grip, which should have a groove running the length of the underside.

As for the wires and leads on the underside of the barrel ear, the screen-used throwers had a short length of heat shrink tubing on the ear itself to keep everything secure.

On the resin kit that I have the front handle and grip are all one piece so sadly I can’t run mine like that. I’ll have to look up some pictures of that because I hadn’t thought of that. Thank you.

I have a TC kit with the molded front end like yours. The trick is to drill a hole from the outside of the ear piece into the tube. There is a groove inside the resin emitter tube for these wires.

Hope this helps! Good luck!

Hmmmm I’ll have to take mine apart and look for that. Thanks for the help. Was just feeling that it was looking a little sloppy.

Also what did you use to heat shrink on the end of the thrower?

All the stuff I know if is small and for wiring.

You have to find square or rectangular heat shrink tubing.

Shrink tubing comes in either round or flat…