Until AJ has the time to revamp the main plans page, I figured I would host JPEG versions of the detail parts for the wand. Assembly drawings are in the process of being finished.
sweet.
Wait a minute, I gots to start over.
I just made myself sad. 
This is some good stuff…
Should have said it earlier
This is amazing, thanks for all the hard work
Thank you, thank you, many times over. Looking forward to the rest of the drawings.
Just what I was looking for this morning…front barrel dimensions. Thanks for posting this, man!
Finally got them posted huh? (sorta)
Hope everyone appreciates the amount of work that went into these. They’ve been in progress for well over a year.
You’ve done the community a great service fellas. Huge thanks to TJ and those that helped contribute research & measurements!
I’m gonna go ahead and sticky this thread.
Oops, never mind, one of you other geniuses already stickied it 
That was Matt. 
Plans located here: http://www.gbfans.com/equipment/plans/elite-proton-pack-plans/
Awesome. Thanks to all involved.
Thank you! These look great
Great looking stuff, one side note the barrel / beam emitter on the gun is a bit shorter, it clocks in at around 4 1/2 " long .
It doesn’t affect the OML or the barrel extend (if added), so it’s a non-issue.
6" is the standard size they are sold at. Its adjustable.
Those look absolutely fantastic. Finally, accurate thrower plans! Great work, man. :crunch:
These are awesome!! Great job!!
How long is the Barrel Spacer supposed to be? Is there a number or just use whatever works better?
great friggin job !