Seller info:
Dan Wymbs
6 Horizon Rd
Fort Lee, NJ
$800
All items are 3D printed. The pack, thrower and trap are 3D printed out of various filament types and is missing a motherboard and ALICE frame and designed by Ghostbusters Gear on Patreon and printed by me. The PKE Meter is from EctoProps on Etsy from a few years back.
The pack has static lights and sound. The Ion Arm was modified to be a battery box and the lid shuts snuggly and locks down with velcro. The sound board is a GBFans sound card (located in the thrower) which the lights are run through for power. The power source is a 12volt battery pack. The voltage meter is connected to the battery and WORKS… kinda. Full power is at 50% on the meter. The trap is a static prop, but the “cable” and pedal can be disconnected from the trap by twisting the connector counter clockwise (forgot to show that in the video). The tip is printed in a translucent blue TPU. The front half of the barrel is also printed in black TPU. This allows the thrower to have some give if it gets snagged or dropped without anything snapping.
The PKE meter has static lights and the antennae can be adjusted manually and runs off of AA batteries located on the rear of the meter. The antennae can be manually lowered into the body of the PKE and takes a little effort to pull out of the body, so you don’t have to worry about it sliding out accidentally.
The pack was printed a couple years ago when I was relatively inexperienced so there are flaws and a bit of warping in a few spots. There’s also a small issue with the battery connector where if it’s at a certain angle, or bumped, you’ll lose power to the pack.
I’m selling this because I’ve kind of lost my love for the pack itself and would rather the gear go to someone who doesn’t mind a slight fixer-upper.
Video of the pack and features.
