I thought I was done with the Gizmo kits, but wanted to have one last try at getting dark circuit boards with green traces made. Been looking for a manufacture to make these for years, and did another huge round of quotes to try and find someone to make these. It is hard to explain colors as important requirements to most PCB manufacturers!!!
But one came back and said they were willing to try! After spending way too much time and money, I did receive a couple of sample boards and this is by far the closest I have ever come to getting boards that look like the 1980’s Sanyo circuit board’s colors.
Seller Info:
Doug Keithley
Boise, ID USA
Doug @ GhostLab42 . com
First round of kits are now available!
Finished building up the first Full Gizmo Kit (it is only available as a kit with lots of parts):
Yes im interested in 1 full kit. Also if the new screw down error box can be retrofitted to the old kit, it would be awesome to be able to buy those separately. Thanks
I should have everything by the end of this weekend, so can build up one kit and make sure the instructions are updated and all of the parts have actually been obtained. If all goes well, some kits should be available by the end of next week.
For an example hurdle, the LEDs I received had very short leads, so I can only build up a few kits with the previous LEDs I already had. It may be a while before the bulk of the correct (I hope) LEDs arrive.
Heat shrink tubing supply issues… For some reason the smaller heat shrink tubing manufacturers / suppliers are now making 3/64" (1/2mm) ID tubing the same size as 5/64" (2.0mm). But only for some colors??? Ordering yet another set of tubing and hopefully this will show up by the end of this week. So no mounting of display tubes yet, but here is the build so far:
I have a kit from the previous run of brown boards that I have not built yet. Would it be possible to just buy the larger board from you and build the previous kit with it? If so I’d love to get a board and keep the brown board as a community collectors piece.
Most of the parts are soldered in place just for mechanical reasons. There are some that are definitely electrical, so if you want the lighting to work, the soldering needs to be adequate for those components…
Currently no plans for assembled kits, but never say never!