This is a quick demo of some of the Ghost trap features from the prop my father (jimfin) and I (Sephiroth) constructed. It is based on the “hero” trap from the first Ghostbusters film. It has rolling wheels (roller-skate bearings), working doors that are activated by the foot pedal, removable cartridge with handle release, and smoke FX (e-cig water vapor) built in that can be turned on/off. We’ve been working on it together for nearly 5 months at this point. My father hand-constructed the majority of it with mostly aluminum and some styrene parts and the trap weighs apprx 11 lbs. It uses a Hyperdyne light kit with dual servo motors. V-Hook and holster produced by Anhcon. Vinyl labels were produced by Crix/Vincenzo330, Aluminum labels from MMM. A majority of the real-world parts were ordered from GBFans and MMM.
I’ll post more detailed build/finished pics later and my father will chime in to discuss the technical specifics.
Thank you, we worked very hard to make it look as authentic to the original prop as possible. It’s not completely screen accurate, but we are very happy with how it turned out overall.
Below are some comparison pics with our GB1 trap next to a Matty GB 2 trap:
I am working on one and had an idea about connecting the cable to the trap, and I saw how it was done on your’s. I am wondering how was the plug attached to the pneumatic connection.
Thank you for the compliments and interest. I took the air hose connectors apart and removed the guts. The mini-connectors for the wire are 2.5mm TRRS (tip, ring ring, sleeve). 3.5mm or 1/8’ are easier to find, but I think they are too big to fit in the pneumatic fittings. I had to use my lighted-magnifier to solder the wire to the mini-plugs as the solder lugs are miniscule. I have to build another plug when it arrives in a few days and I’ll try to take some pics of the solder job. I needed 4 wires from the pedal to the trap, 2 for the signal to the Hyperdyne kit to open /close the doors and 2 wires from the DPDT switch that I used on the cartridge to go back to the pedal to turn on the LED on the pedal. I used 2 AAA batteries in the plastic box to power the red LED on the pedal, That way it comes on when the cartridge is turned on, the smoke is coming from a Halo G6 ecigi got the longest battery (105mm) and the clear atomizer cartridge. I’m still experimenting, but it is working pretty good as is. I bought a Vellman timer/switch kit that that runs off a 12v 1000Mah battery installed in the main cartridge. I needed 6v for the mini air pump so I built a small circuit board using a Radio Shack variable voltage regulator connected to the ouput of the relay on the Vellman board. I made an adapter from the air hose to the lighted end of the G6 battery from a rubber cap I found at Advance Auto, I’m using glycerin (for skin care from Rite Aid) mixed 1 to 1 with some fog juice (poly glycol) I used in my DJ fog machine. The e-cig also worked pretty well using the glycerin mixed 50/50 with water.
I’m waiting on some mini air pumps from china that have suction and pressure nipples and try to hook them up to the other end of the e-cigs to see if it produces more smoke/vapor.
BTW, the timer is required…about 2 sec on 2 sec off to avoid the Halos internal protection circuit from turning off the battery which occurs if you puff more than about 3 seconds constant.
I’ve seen this in person a couple of times now and it is VERY impressive. Honestly the video and pics don’t do it justice, just the weight of the thing is awesome.