Anybody have pics or step by step on how they are mounting the bar graph in the gun body along with the 3D printed frame? Just looking for ideas…
I’ve also ordered this items and yes, every advice and idea will be a great help. 
I put a dab of hot glue on either side of the bar graph board and press it into place. For the bezel, I put a very tiny drop of super glue on the top and bottom edge of the bezel where it will contact the gun body. It was made to be a press fit but I worry about it getting knocked off so I back it up with a tiny amount of glue. Same thing goes for the screens of the bezel. Be VERY careful to use a very tiny amount as the glue and the plexi glass and glue will react in a bad way to each other if you use to much. This method has worked great on the 2 kits I’ve installed.
Would you use hot glue to mount the other electronics, Joe?
Same thing for aluminum bodied throwers?
I mounted the gun board to the side of the gun body with Velcro. That way if I need to remove it, it can pop right out. I always hot glue the LEDs into the light caps though.
I was thinking of attaching the bar graph to a thin piece of aluminum cut to fit inside the gun body and have it held in place by the switches…
Mh, that’s seems a very good idea! I’ll try this when I’ll receive my Gun Light Kit!