In between working on my first proton pack, slime blower and RGB pack, I decided that it would be a good idea to build a life size slimer sculpture. I’m not quite finished, but I thought I would post my progress up to this point, in case anyone had some tips or suggestions. I am not good at sculpting things and there are people that could do this a lot more justice than I could. Maybe if anything, it will inspire someone to do the same…
I started with a small 5" rubber ball from target. Pretty sure it had princess’s on it (but that detail is not important)
Here you can see it starting to take shape. I just kept slapping ■■■■■ of news paper on to the thing and taping them down until I got the shape I wanted.
The only trouble I am having is, even after the gesso, I have cracks showing in places. That’s kinda why I was thinking bondo. I havent done any work with fiberglass yet, so maybe I will try that. Thanks!
I used elmer’s wood putty on cracks, and it worked fine. I’d add a top layer or two of house paint (to get a smooth surface), and then lightly sand that. If you already have gesso on, fiberglass might just be additional overkill work.
EDIT: I didn’t notice your last “cake icing” pic. It looks like you made your gesso much too thick. It shouldn’t be like cake icing, but should be more like a slighty thinned house paint constancy.
That stuff cures like rock, and you might have a tough time dremmelling the teeth to get your detail back.
If that ends up being the case, a possibility might be to cut the teeth out, and then make him sculpey “dentures” so they can have detail. Once cured you can glue em in, and just paint em up, since they will already have a hard surface.
To give him a nice shiny “wet” gloss coat, locate some Johnson and Johnson floor wax “Powered by Future” You can brush or spray that on, and it will add a waterproof VERY wet look once dry. You can even use it as a thinner for waterbased outpaint or water based acrylic paint to add some additional gloss to them as well.
Didn’t mean to neglect the topic, i have just been busy and once I actually painted it, i wasn’t thrilled with the result. Here is what I have so far… i first went with the movie style eyes, and then switched to the animated (which I like better). still needs work though
For eyes, maybe pick up a few of those plastic easter eggs that have 1/2 clear, and open the long way. Use th eclear parts as eye outers, maybe add upper or lower lids, and maybe use ping pong balls for the eye centers?
How flexible is it? It there any pose ability at all? I have been working on a project of something similar but have been considered starting with a wire frame in order to be able to pose the hands and fingers a bit.