I was wondering on how some of you installed the power cells lights to the pack. At the moment I’m not sure how I want to mount them. I mean I could hot glue it to the blue lens but it would look kinda tacky. Just fetching for some ideas. Thanks
The best method is to make a small bracket to mount the Power Cell lights to that is positioned directly behind the blue lens and attached to the motherboard.
That sounds better then hot glue, Any idea what kind of bracket I would need. I am very new to all of this. Thanks much
It’ll depend a little on what the board for your power cell lights look like.
If the lights are mounted on the face of a thin, strip-like board, then these methods are the most straightforward:
If however your lights are mounted to the edge of the board, a slightly different approach will be needed (and also prepared in order to avoid accidental arcing/short-circuiting if the mounting method is made of metal:
The two packs I’ve made use 3D printed shells. I designed a bracket that bolts to the shell that holds the power cell lens and lights. I’ll post some pictures of it later today.