Question about metal v-hooks sold on this site

Hello! I have the Haslab proton pack and neutrona wand, and the v-hooks on mine have never slid very well together (they go just past halfway, something I understand is a fairly common issue). Since I’m planning to dress up in my costume for Halloween and will be out and about, I want to upgrade to something more sturdy.

The v-hook in the shop on this site says that for the G1 version of the product, it “mounts from inside the pack and will require shortening the screws to fit the thickness of your pack”. Can anyone who has ordered this product explain what this means, “mounts from inside the pack”? I was assuming it would work with the Haslab pack, and I imagined I would just simply screw off the old ones and screw the new ones in their place (I understand I need to take apart the pack to do this). But it sounds like it might not quite be that simple?

Any guidance would be appreciated! Thank you!

To install the v-hook sold via the store you would need to remove the stock v-hook including the plastic mounting block under the metal part, cut off the plastic posts the mounting block slots onto, drill new holes for the screws for the gbfans v-hook and then install it. What it means by “mounts from inside the pack” is that it use socket cap screws that screw in from inside the pack. These would need shortening by you, as the wall thickness of the Haslab pack is a lot thinner than a traditional pack that they are designed for.

There’s a few folk sell replacement v-hooks specifically for the Haslab pack, me among them. I’ll be restocking in about a week, I have a sale thread in the Sales forum if you want to take a look at it.

Fantastic! You’ve just got yourself a customer! Do you sell both the male and female parts or just the one that goes on the pack itself?

Just the pack half. It’s designed to work with the wand half, so you don’t need to replace that.