whaat did u use to draw the circle of the synch generator
I used a pencil personally. A pen might not be too bad though. :whatever:
http://www.gbfans.com/equipment/plans/norm-gagnon/
Norm’s plans give pretty good instructions on it. The first page, I believe. The best way to find the center of the circle and all that.
not sure, but I think you’re asking what tool to use to make a decent circle that large?
if not, oh well, it’s something I was wondering earlier too, but it’s pretty easy.
I doubt most people will have a compass large enough, so instead you can take any rigid stick that you don’t mind drilling into a little bit. Just measure out the radius on the object (could even be a plastic ruler), and drill two small holes at the beginning and end of your radius measurement. Then use a pencil in each hole, keep one stationary, move the other one 360 degrees. Ta-da! Hope that helps the original poster or anyone else wondering about that.
edit: see post below. bingo
