I have started the process of building my first pack (I had one given to me as a gift by my mother, but that only makes me want to build one even more! Lol), and have already started talking with a few people here for parts (thanks again if you’re in that list!)
Does anyone have a list of “trade” tools that make the process(es) easier? Any help or advise would be greatly appreciated!
If we get enough info here I will make a properly formatted list (giving credit where due of course) for other people with similar questions
Mistake number one people make with dremels, its not made to cut everything. Cutting wheels are not made for wood, plastic, or aluminum. They’re good for cutting tiny metal things like nails or small screws, and perfect for slotting that 10-32 bolt for your banjos!
If you’re going to cut sheet aluminum, you can go slow with shears, or fast with a jigsaw (my favorite).
Soldering gun will take care of wires. If you’re doing aluminum and brave enough, you can go torch and rod, or expensive welder. If you don’t mind the look, pop rivets work too.
If you’re working with fiberglass, check out the multimax.
Clamps: The long adjustable clamps are helpful for clamping down the shell while drilling your mounting bracket holes, as well for clamping down parts if you wish to glue/epoxy them. Harborfreight has really cheap clamps
Small Drill Press: Can be very very helpful in making sure your holes are drilled straight for mounting parts. Nothing is more annoying than drilling through a part on a slight angle.
Epoxy/Glue: I don’t like to permanently epoxy my parts down but some people do. I recommend getting the 2 part kind that comes in 2 separate bottles that you mix and apply yourselves. The small “5 minute syringe” kind you can get is basically a 1 or 2 time use deal and then you have to throw it out. You can use the bottled kind to mix on a paper plate or something and apply it with some scrap or a spreader.
Dremel/Small Files: Great for widening mounting holes or doing stuff like evening out parts of your shell on the inside.
Cordless Drill/Bit set. Most of the drilling you will be doing will be with your tapping combo drill bits but you will still need 1/4", 3/16" and 1/8" bits to drill mounting holes on your shell and mobo ect.
Hot glue gun for the proton pack lenses: Only place I would use hot glue, I’ve used epoxy and it is very runny and can get on the lenses and make them smeared. Hot glue is pretty controlled and the excess can be picked off. Never failed on me.
Then obviously paint and primer.
Since most parts these days are pre-fabricated resin and aluminum parts, you really only need the above to put together a proton pack.
The drill press is really really helpful, you can get a small table top one for cheap. That will ensure nice straight holes for your bracket rivets, your resin parts ect.
Links in this post may be affiliate links. Purchases made through them help support this site at no additional cost to you.