Yes I’m starting on a slime blower and I’ve ran into a problem, I bought a 8inch in diameter concrete form tube and I can’t find a plastic dome that has a 8 inch diameter. I went to www,barnardltd.com, and they don’t have one in that measurement if someone could find a site that I could buy a plastic dome with 8in diameter I’d appreciate it.
Phone your local plastics companies and ask if they produce an 8" dome in styrene or PVC sheet, or if they can put you in touch with a company that forms domes. Once you start making calls, you will find about a dozen who offer them.
It’s then a matter of securing the best price.
www,barnardltd.com, its a location in chicago that sell the ones I used and in multiple sizes
Thats the thing they don’t have one in 8 inch.
Hey tell me if this would work:
I mean, if you put the 8 inch topiary ball on the end of the tube, it’ll fit right into place. Now, that material is VERY plyable, so you’ll want to be careful. My advice would be to bondo the entire ball onto the tube, and then hand sand the ball smooth. It should actually turn out nice.
Mixing bolws.
You can find them anywhere really cheap.
And once they’re sprayed…

They look pretty good ![]()
go with the 9", you can always adjust it, but I think I went witht eh 9" when I scaled the main tank with the cyclotron. 8" might be a bit small but it should work.
My 8 inch tube was actually a little over 8 1/2 so I think anywhere around there should work out pretty nicely! :whatever: If you figure the smaller tanks being 4ish.
I agree with the mixing bowl sentiment ff you end up going that route. They end up pretty nice! Though I think Goose found a little better bowls than I did! :walterpeck:
Thanks for all of the help, guys. I think i’ll just go with the mixing bowl idea for the tank. Again thanks. ![]()