Rubber scratch built hose connector WIP

Hey everyone,

I’ve just come back from Clark Rubber (a pool/rubber supply chain in Australia), where I was looking around for a few things for my first GB costume and I ended up scratch building a hose connector in store.

It’s not accurate, but it’ll do the job nicely, especially as I’ve built it in such a way that I’ll be able to easily break it down for laundering my uniform.

Please forgive the crappy photos, I’m not used to this camera and I hate with a burning passion auto-focus only cameras (for this exact reason).

Picture 1: Separate pieces

image

Picture 2: Combined to make Voltron.

image

Parts List:

1x White Chair Tip 22mm

1x Grey Crutch Tip (with washer)

1x Black Castor Cup

My plan is to drill the white part with a hole just smaller then the hose, and then secure it with a cable tie (it fits so well in the grey part that the friction between the two rubbers holds it together, but can be pulled apart with a tug). The grey part I’ll drill out and through to the black part so it can be bolted together. The black part itself will be permanently sewn onto the uniform (when it finally arrives), with a hole cut out of the leg for the bolt to be removed for cleaning.

The parts cost just over AU$6, and all it requires is a little paint, a couple of holes and a small bolt.

Not bad, though I think you’re going to run into problems if you try to paint it.

Yeah, what JackDoud said. The crutch foot might be ok, but the black castor cup and white tip might be problematic if it’s vinyl. What color are you going to paint it?

When I painted mine, I used spraypaint. Hand-painting it with a different kind of paint might be an option. Give it a shot!

It’s all rubber, so I’m gonna undercoat first and then spray the whole thing grey.

I drilled out the holes yesterday and poked a hole through, and it’s looking pretty good. Just need to find a decent nut/bolt/washer for the bottom bit and finish drilling out the 6 holes on the caster (which I forgot to do yesterday)

Parts drilled

image

Combined (unpainted)

image

(Note, the black thing in the end is just a paint brush to hold it together for the shot)

Oh, one last thing for anyone who wants to drill rubber. Pilot hole with a small bit first and stage up gradually, and try and use sharp bits (my large bit for the hose was a little dull it chewed the hole a bit).