So im finishing up my pack, hoping to have it ready by the end of next week, and the only thing I’m missing now is the GUN GRIPS! i want them rubber and i need them like yesterday…any ideas? 
They’ve been done, but not recently that I’ve seen. You may get lucky and find someone with an old set they’re willing to get rid of, otherwise your best bet is to find someone with molds and convince them to run some rubber. Not going to be cheap though.
Or you could get resin grips and spray them with a product like Plasti-Dip which will make them feel and appear to be rubber. Might be cheaper, but they won’t be rubber all the way thru.
I’ve had bad luck with Plasi-Dip adhering to resin grips. It starts to peels, then huge strips just peel off at once (and before anyone asks, yes that’s with sanding and primer).
Sent from my DROIDX using Ghostbusters Fans on Android
Same issue with plastidip here
okay thanks 
Two thumbs down for plasti-dip… Bad times.
One thing that is commonly over looked. is make sure they grips you want, fit the tubing you’re using for your gun.
I had rubber grips on my last thrower. I had an aluminum front handle, and a thin walled pvc handle in the back. The grips fit the pvc perfectly but were a little too large for the aluminum one. I got them to work, but was a royal pain.